
Your “Precision Tune-Up and Professional Cleaning” Consists of These 34 Individual Operations:
- Inspect Heat Exchanger
- Inspect Drain Pan for Build Up
- Inspect All Safety Controls
- Light Pilot Assembly If Required
- Clean Burners If Required
- Clean & Adjust Pilot Assembly/ Thermocouple
- Inspect Fuse/Breaker Assembly
- Adjust Burner
- Inspect for Gas Leaks
- Lubricate all Moving Parts (where applicable)
- Inspect Air Filters
- Check Flue Pipe & Draft
- Inspect Fan Control
- Check for Proper Temperature Rise
- Clean Condensate Trap If Applicable
- Inspect for Carbon Monoxide
- Monitor Compressor For Proper Amperage, Volt Draw and Wiring Connections (where applicable)
- Inspect Complete Heat Cycle
- Inspect all Electrical Elements
- Inspect High Limit
- Inspect Bearings on Blower and Motor
- Inspect Condenser Coil
- Monitor Operation Pressures of refrigerant (if applicable)
- Inspect Safety Devices for Proper Operation
- Inspect disconnect box for proper rating and installation
- Tighten All Electrical Connections
- Test/Inspect Contactors for Burned, Pitted Contacts
- Inspect Electrical For Exposed Wiring
- Test and Inspect Capacitors
- Inspect Fan Blade
- Clean Condenser Coil/Remove Debris (if applicable)
Inspect Service Valves For Proper Operation (if applicable)
- Measure Temperature Differences – Supply/Return
- Inspect Ductwork For Energy Loss